We are accepting orders on a limited range of products. Due to unprecedented customer demand, there is a limit on the number of orders we can take daily.
As we are currently experiencing a large volume of queries, our response time may take longer than usual. Thank you for your patience and understanding at this time.
We are accepting orders on a limited range of products. Due to unprecedented customer demand, there is a limit on the number of orders we can take daily.
As we are currently experiencing a large volume of queries, our response time may take longer than usual. Thank you for your patience and understanding at this time.

Let's Make A Jewellery Holder

 

1. Cut Cube to Size


Saw timber into a square - 2 x 2cm

2. Cut Dowel to Length


Saw dowel to length - 1 x 25cm

 

3. Lightly Sand


Lightly sand the square and dowel using a sanding block.

4. Spray Paint


Spray paint the dowel 3 or 4 times usimg Rust-Oleum gold metallic and let it dry for 1 hour

 

5. Drill Hole


Drill a hold the size of the dowel through the square (in the middle)  

6. Glue in Place


Glue dowel into a square hole.

7. Attach to Wall


Attach to Wall

8. Ta Da!!